Power Window Sw Replacement - Driver Door

[sperry]

Switch Replacement (03+) Door Lock and Side Window - Driver Door

2003 ~ 2006. For 2002, Click HERE

Removal Procedure


   1. Remove the front door trim panel. Refer to Trim Panel Replacement - Side Front Door.
   2. Disconnect the electrical connectors.
   3. Remove the screw that retains the switch panel bezel (1) from the front door panel.



   4. Remove the switch panel bezel from the door panel using a flat-bladed tool.



   5. Using a wide plastic flat-bladed tool, release the retaining clips on both sides of the door module.
   6. Remove the door module from the switch panel bezel.

Installation Procedure



   1. Install the door module into the switch panel bezel until it snaps into place.



   2. Install the switch panel bezel and module to the door panel.

      Notice: Refer to Fastener Notice Caution[/url] .



   3. Install the screw that retains the switch panel bezel (1) to the front door panel.

      Tighten

      Tighten the screw to 2 N·m (18 lb in).
   4. Connect the electrical connectors.
   5. Install the front door trim panel. Refer to Trim Panel Replacement - Side Front Door .
   6. If equipped with camper mirrors program the door module.

------------

Minor edit: Color of one link...

[sperry]

Here is a link with actual photos and instructions, provided by member: sennister.

Driver's door PW Window Switch Repair

Note to use Electrostatic Discharge precaution. (ESD)

Touching components where ESD precaution is not followed would lead to premature failure of sensitive components.

Here's a link to an ESD Product Vendor.