Please login or register.

Login with username, password and session length
Advanced search  

News:

Keep CAFCNA Alive! Become a Supporting Member Today!

Pages: [1]   Go Down

Author Topic: Transfer Case - NVG 236/246-NP8 Replacement  (Read 13911 times)

0 Members and 1 Guest are viewing this topic.

ItsStopher

  • CAFCNA Global Moderator
  • Full Member
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • *
  • Offline Offline
  • Posts: 5,445
Transfer Case - NVG 236/246-NP8 Replacement
« on: June 9, 2010, 21:35:39 PM »

Transfer Case Assembly Replacement

Removal Procedure



1. Raise the vehicle.
2. Remove the transfer case shields. 
3. Remove the front propeller shaft. 
4. Remove the rear propeller shaft.



5. Disconnect the motor/encoder electrical connector.



6. Remove the transfer case vent hose.



7. Remove the electrical wiring harness from the transfer case.
8. Support the transfer case with a suitable transmission jack.




Important

When removing the transfer case from the transmission, do not remove the transmission mount or the transfer case adapter.

9. Remove the transfer case retaining nuts from the transfer case studs.



10. Separate the transfer case from the transmission by moving the transfer case straight back toward the rear of the vehicle.
11. Rotate the transfer case so that the transfer case is perpendicular to the transmission assembly.
12. Lower the transfer case.


Installation Procedure



1. Rotate the transfer case so that the transfer case is perpendicular to the transmission assembly.
2. Raise the transfer case into position.
3. Rotate the transfer case so that the transfer case aligns with the transfer case adapter.
4. Install the transfer case assembly.



5. Install the transfer case retaining nuts. Tighten the transfer case retaining nuts to 50 Nm (37 lb ft).



6. Install the transfer case vent hose.



7. Install the electrical wiring harness to the transfer case.



8. Connect the motor/encoder electrical connector.
9. Install the front propeller shaft.
10. Install the rear propeller shaft.
11. Inspect the transfer case fluid level.



12. Install the transfer case shield.
13. Lower the vehicle.
« Last Edit: June 9, 2010, 21:48:28 PM by ItsStopher »
Logged
Pages: [1]   Go Up
 

Page created in 0.133 seconds with 25 queries.