I have purchased a Peak 1200 watt work zone power inverter http://www.peakauto.com/products/electronics/mobile-power-outlets/1200-watt-work-zone-mobile-power-outlet-kit/ and am open to suggestions on ways to install it .
It comes with a 10 foot remote dual receptacle outlet that also has a usb port and a remote on/off switch.
Right now I am planning to run the remote outlet from the drivers side saddle bag by drilling a hole in the bottom of the saddle bag and routing the wire along the frame up to the rear passenger seat floor board and drilling a hole to run the wire into the cabin to connect to the power inverter.
I am planning on purchasing positive and negative cables in 2/0 size as per manufacture suggestions and since these cables are so large don't think they will run along inside the "rail" covered by the trim pieces at the bottom of the door so I was planning on drilling more 2 more holes under the passenger seat and routing the cables along the frame up to the single battery as well I am adding a 200 amp circuit breaker.
All wires ran along the frame will be wire loomed and all holes will get a grommet and I will add silicone as an added measure to keep water out .
If you can think of any other ways to route the wires without so much drilling that would be awesome.
It comes with a 10 foot remote dual receptacle outlet that also has a usb port and a remote on/off switch.
Right now I am planning to run the remote outlet from the drivers side saddle bag by drilling a hole in the bottom of the saddle bag and routing the wire along the frame up to the rear passenger seat floor board and drilling a hole to run the wire into the cabin to connect to the power inverter.
I am planning on purchasing positive and negative cables in 2/0 size as per manufacture suggestions and since these cables are so large don't think they will run along inside the "rail" covered by the trim pieces at the bottom of the door so I was planning on drilling more 2 more holes under the passenger seat and routing the cables along the frame up to the single battery as well I am adding a 200 amp circuit breaker.
All wires ran along the frame will be wire loomed and all holes will get a grommet and I will add silicone as an added measure to keep water out .
If you can think of any other ways to route the wires without so much drilling that would be awesome.