blazzinbird
Full Member
So I bought a autometer gauge and gauge pod for the a pillar. Anyways today I crawl under the truck and look for the port by the shift linkage. Problem is, the transfer case is in the way.
So I am going to put it inline from the factory cooler. I figure I need a
T fitting
2 compression fitting "I don't know the size of the ID of the tubes"
Some brass tubes"refer to the line above"
Does anyone know what size fittings I would need?
Mods if this is in the wrong section please move. M
So I am going to put it inline from the factory cooler. I figure I need a
T fitting
2 compression fitting "I don't know the size of the ID of the tubes"
Some brass tubes"refer to the line above"
Does anyone know what size fittings I would need?
Mods if this is in the wrong section please move. M