Red Baron
Full Member
I have dual temp control knobs and lately have used heat a week ago with no problems, now when I try to use the A/C again the driver's side still blows out heat, does anyone know what's up with that??
EXT4ME said:You can try the reset procedure and see if that helps.
First, start the truck and then turn EVERYTHING on your HVAC to OFF.
Shut down the truck and disconnect the battery for a minute or two.
Reconnect the battery.
Start the truck and cycle through all of the settings on your HVAC system.
If this fixes the problem, you are done.
Of not, you most likely have a blend door actuator going bad.
Plenty of threads in this forum on that repair.
Mine has always taken the reset procedure.
But replacing the blend door actuator is not that bad a deal, either.
Best of luck.
PS: Put your truck info in your forum signature so others will know what your have without having to ask sometime down the line.