OK I think I got everything
First remove the dash surround
Turn the ignition key to run do not start
Put you foot on the brakes to stop the car from rolling
Move the shift lever to 1 or L (low)
Tilt the steering wheel all the way down
Pull the dash surround off it?s held on with clips
Put shifter back in back in park and turn the ignition off.
Remove the fuse labeled SIR wait 15 minutes for backup power to drain
DO NOT turn the key on after this step, or it will set a air bag code and may phone into On Star
Front Seats
Carefully remove the lower trim (plastic stuff) it pulls off and remove the door sills they pry straight up
Move the Seats all the way back and remove the front seats bolts from the seat rails, these are Torx nuts and carefully remove them using a 11mm or 15mm deepwell socket (They will not fit tightly, but you can get them off with one or the other size. If you drop the nut in the rail which is easy to do you will need a magnet to get it out.
Move the seats all the way up and remove the Torx bolts using a 11mm or 15mm deepwell socket (They will not fit tightly, but you can get them off with one or the other size
Disconnect the Yellow Air Bag connection at the back of the seat, first remove the safety pin in the connector then pull up on the catch and slide the connector apart, don?t pull on the wires.
Disconnect the main seat harness by first removing the safety pin (If you have one) and disconnect the harness by pushing down the catch and pulling it apart.
You can now lift the seats up and out of the AV. The seats are heavy and have to be lifted up and over some locator pins and rear heat ducts (DO NOT DRAG IT OUT)
Console
The console is held down by 4 seat bolts which you have removed already, but it?s held in by 2 more bolts in front of the console
Remove the upper console bezel; disconnect the cig lighter wire connection for the back of it.
You will now see the 2 bolts holding the front, remove them.
Pull the console cup holder straight up to remove it.
Below the cup holder you will see the console wiring harness connector, slide the white locking bar up and you will
Carefully remove the console, make sure the main wiring harness is not stressed and slides away from the console. You also have to watch the duct for the rear console vents make sure it slides out from the main air duct system
Rear Seat
Remove the front and rear trim cover.
Remove the jack assembly
Remove the trim (plastic) to access the seat bolts
Remove the bolts
Remove the seats