New to the forum here and appreciate any help. I have a 2002 Avalanche 2500 with the 8 liter big block and allison transmission. She is a beast and have had her for almost 12 years. A few months ago the radiator started leaking where the plastic and aluminum bits maye up near the bottom. Took awhile but I finally found a new radiator, problem is I got it in and the fittings for the built in motor oil cooler on the drivers side of the radiator were the wrong size. It was an online order from orielys, so I call them up and they say I have to go through Murray's who manufactured it. Called Murray and they sent me more fittings but they are the same ones it came with the first time. Called Murray back and they basically say sorry for your luck, and they can't help me. Has anyone run into this issue? They are the quick fit snap on metal fittings like a typical trans line fitting but it's for the motor oil cooler. Right now I have a high pressure rubber hose on the lines just bypassing the cooler but I dont trust it getting g far like that, the big block beast has a lot of oil pressure!