• If you currently own, previously owned or want to own an Avalanche, we welcome you to become a member today. Membership is FREE, register now!

2005 Remote Start Wire Guide

itsstopher

PM 2018
PM 2017
PM 2016
PM 2015
PM 2014
PM 2013
PM 2012
SM 2011
SM 2010
SM 2009
SM 2008
SM 2007
SM 2006
SM 2005
SM 2004
SM 2003
Full Member
Joined
Sep 2, 2004
Messages
5,470
Location
Gilford New Hampshire
Function? ? ? ? ? ? ? ? ?Color? ? ? ? ? Polarity? ? ?Location
12v Constant? ? ? ? ? Red? ? ? ? ? ? ? ? +? ? ? ? ? Ignition switch harness
Starter 1? ? ? ? ? ? ? ? Yellow? ? ? ? ? ? ?+? ? ? ? ? Ignition switch harness
Ignition 1? ? ? ? ? ? ? ? Pink? ? ? ? ? ? ? ? +? ? ? ? ? Ignition switch harness
Ignition 2? ? ? ? ? ?? ? White?? ? ? ?? ? ? +?? ? ? ? Ignition switch harness
Accessory 1? ? ? ? ?Orange? ? ? ? ? ? ? +? ? ? ? ?Ignition switch harness
Tach? ? ? ? ? ? ? ? ? ? ?White (3)? ? ? ? ? AC? ? ? ?At PCM pin 10 in green connector?
Brake switch?? ? ? ? White? ? ? ? ? ? ? ?+? ? ? ? At brake switch
Parking lights? ? ? Gray/black? ? ? ? ? -? ? ? ? ?At BCM pin B2 in brown connector
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?or at headlight switch
Lock? ? ? ? ? ? ? ? ? ? ? ?Door lock or Data Bus interface needed
Unlock? ? ? ? ? ? ? ? ? ?Door lock or Data Bus interface needed
Dome light? ? ? ? ? ? Gray/Black? ? ? ? ?+? ? ? ?Black Plug At BCM
Factory Disarm? ? ?Lt.green (4)? ? ? ?-? ? ? ? At driver door module in door
Door Trigger? ? ? ? ?see notes (2)
Parking Brake? ? ? ?Lt.blue? ? ? ? ? ? ? ?-? ? ? ? At parking brake switch
Horn? ? ? ? ? ? ? ? ? ? ? ?Black? ? ? ? ? ? ? ? -? ? ? ? At BCM pin B9 in grey connector
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?or sterring column harness
Rear defrost? ? ? ? ? White? ? ? ? ? ? ? ? -? ? ? ? At BCM in Gray conn. Pin A8

OEM Anti-theft: Yes Type: PassLock 2

Notes:
PLEASE NOTE: Passlock wires are at BCM in grey connector. Yellow (signal wire) is pin B3 and black (ground wire) is pin A2 Can also be found at the ignition harness.
(1) These wire color are for basic model only (no power windows). You can also found these wires in 9 pin connector coming out of driver's side fusebox. As for the upper models, there are modules in each door. You must use data module to control the doorlocks or relays for reversing polarity in each door.
(2) You must use these wires and isolate each with diode Basic model:
LF=Gray/black pin B4 lt.blue conn, RF=Black/white pin C4 lt.blue conn, LR=Lt.blue/black pin A3 purple conn, RR=Lt.green/black pin A2 purple conn Upper model: LF=Gray/black pin B4 lt.blue conn @ driver's door module, RF=Black/white pin C4 lt.blue conn @ pass. door module, LR=Lt.blue/black pin A3 purple conn, RR=Lt.green/black pin A2 purple conn
(3) The PCM is located on driver side of engine, close to battery. The tach wire is located on connector C1 pin 10, White wire.
(4) OEM remotes arm & disarm but doesn't work when the engine is running. You must use a data module to control the factory alarm.

03,04,05BCM.JPG
 
Just a heads up on the 2005 Av. The dome light @BCM is positive, not negative. I just installed a 564t with the 1700G and it works great.
 
Mikeeo said:
Just a heads up on the 2005 Av. The dome light @BCM is positive, not negative. I just installed a 564t with the 1700G and it works great.

Thanks, I fixed it. All the sheets I have say -  ???  I looked up the BCM schematic and confirmed they are +
 
Back
Top