• If you currently own, previously owned or want to own an Avalanche, we welcome you to become a member today. Membership is FREE, register now!

2007 Remote Start Wire Guide

itsstopher

PM 2018
PM 2017
PM 2016
PM 2015
PM 2014
PM 2013
PM 2012
SM 2011
SM 2010
SM 2009
SM 2008
SM 2007
SM 2006
SM 2005
SM 2004
SM 2003
Full Member
Joined
Sep 2, 2004
Messages
5,470
Location
Gilford New Hampshire
Function? ? ? ? ? ? ? ? Color? ? ? ? ? ? ?Polarity? ? ? ? Location
12v Constant? ? ? ?Orange (2A)? ? ? ?+? ? ? ? ? ? ? At BCM (6)
Starter 1? ? ? ? ? ? ? See notes (1)
Ignition 1? ? ? ? ? ? ? Pink? ? ? ? ? ? ? ? ? ?+? ? ? ? ? ? ? At Ignition harness
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?or BCM, Lt. green conn, pin 14(4)?
Accessory 1? ? ? ? ? Brown? ? ? ? ? ? ? ? ?+? ? ? ? ? ? ?At Ignition harness
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?or BCM, Lt. green conn, pin 21 (4)?
Tach? ? ? ? ? ? ? ? ? ?? Lt.green? ? ? ? ? ? ?AC? ? ? ? ? ? ?At large harness from driver side
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?top engine between engine and
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?relay box
Brake switch? ? ? Lt.blue/white? ? ? ? +? ? ? ? ? ? ? At BCM, pink conn, pin 6 (5)
Parking lights? ? ?Dk.blue? ? ? ? ? ? ? ? ?-? ? ? ? ? ? ? At switch
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?or at BCM, Brown conn, pin 8 (4)
Lock? ? ? ? ? ? ? ? ? ?Use Data module (2)
Unlock? ? ? ? ? ? ? ?Use Data module (2)
Factory Disarm? Lt.green or Use Data module(2)
Door Trigger? ? ? ?See notes (3)? ? ? ? -?
Parking Brake? ? ?Lt.blue? ? ? ? ? ? ? ? ? -? ? ? ? ? ? ? At parking brake switch
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? or at BCM, Brown conn (4)
Horn? ? ? ? ? ? ? ? ? ?Tan? ? ? ? ? ? ? ? ? ? ? ? -? ? ? ? ? ? ?At ignition harness
? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? or at BCM, brown conn, pin 18 (4)
Rear defrost? ? ? ?Purple (12 awg)? ? ?REV? ? ? ? In DKP harness going to the rear

OEM Anti-theft: Yes Type: Passlock Hybrid

Notes:
NOTE: This vehicle is equipped with a Passlock Ion and a transponder key (PK3+). To Bypass both system, use a data module. If the vehicle is equipped with factory remote the vehicle is equipped with OEM anti-theft alarm.
(1) This vehicle doe's not have starter wire. The engine will crank on it's own when power is removed from brown wire (accessory), when PK3+ transponder and the passlock value are valid. Use Data module to bypass both at the same time.
(2) Use a data module to control the doorlocks and the factory alarm.
(3) The Driver door is Gray/black (-) and Tan (-) located at the driver door module, brown 16 pin connector, pin 11 & 13. The Passenger door is Tan/white (-) located at the passenger door module, brown 16 pin connector, pin 13. The Driver rear door is Lt.blue/black (-) at the BCM, pink conn, pin 15. The passenger rear door is Lt.green/black (-) at the BCM, pink conn, pin 14. Diode isolate all door triggers. To catch the front door triggers, use a data module.
(4) The BCM (Body Control Module) is to the left of the sterring column.
(5) Ignition key must be ON to test the brake switch.
(6) For high current 12V, use the two Red/black (60A) at the fuse box, black 40 pin connector, pins F1 and E3, or go to the BCM black connector and use any of the red/white 12 volts source.

Note: If you get a horn honk before the runtime, use a relay to open the horn wire (Tan) at the BCM Brown conn. pin 18 during the runtime.
 
dsteinmann said:
Is there a +Parking Light Wire inside anywhere? So i can hook the alarm straight up to it w/no relay?

What is the max power of the wire you want to use? The parking light circuit has a 15A fuse, so if your supply wire has a smaller fuse you will still need a relay. I can tell you where to connect it, but you might have a smoke show  :eek:
 
Back
Top