• If you currently own, previously owned or want to own an Avalanche, we welcome you to become a member today. Membership is FREE, register now!

20x10 fender trimming

kev2809

Full Member
Joined
Oct 28, 2019
Messages
97
I have a 2002 cladded 4x4. only have level keys installed up front. just put some 20x10 -12 offset with 33s. rubs pretty good turning either way. how are u guys trimming the plastic to get them not to rub? looked around on custom offsets and seems everyone with this setup has "minor" trimming but I don't see any actual pictures of the trimming.
 

kev2809

Full Member
Joined
Oct 28, 2019
Messages
97
well, couldn't find any pictures so I did what I could. driver side back fender plastic needed a chunk cut out, a small edge of metal cut, and then beat in with a hammer. bumper just needed a zip tie to the bumper bracket.

passenger side was much easier. same back section cut out. bumper needed a tiny trim at the bottom.

also, both of the cladding on the backside fenders needed small trimmings at the very bottom.
 

Attachments

  • 20210315_171125.jpg
    20210315_171125.jpg
    215.9 KB · Views: 13
  • 20210315_171110.jpg
    20210315_171110.jpg
    146.7 KB · Views: 13
  • 20210315_171214.jpg
    20210315_171214.jpg
    340 KB · Views: 12
Top