20x10 fender trimming

[kev2809]

I have a 2002 cladded 4x4. only have level keys installed up front. just put some 20x10 -12 offset with 33s. rubs pretty good turning either way. how are u guys trimming the plastic to get them not to rub? looked around on custom offsets and seems everyone with this setup has "minor" trimming but I don't see any actual pictures of the trimming.

 

[kev2809]

well, couldn't find any pictures so I did what I could. driver side back fender plastic needed a chunk cut out, a small edge of metal cut, and then beat in with a hammer. bumper just needed a zip tie to the bumper bracket.

passenger side was much easier. same back section cut out. bumper needed a tiny trim at the bottom.

also, both of the cladding on the backside fenders needed small trimmings at the very bottom.