Hi,
I installed a CodeAlarm remote start 5054 and the FLCAN from FlashLogic.
I'm using the data connection method between the RS and the FLCAN.
Everything looks connected properly and I get continuity from the data port and the wires into the flcan.
There is a programming/pairing procedure on the FLCAN even before getting to program the RS.
I get the flashing green light, then the solid green. When I insert key and to 'Start' (the position right before the starter kicks on) where the directions (and crutchfield) say to have it, I never get the confirmation solid green.
Has anyone had this issue? I cannot get to the RS programming.
I have had the ODBII port read before and at one point, the fuse was bad (a while back when i discovered that the Cig lighter is connected through that fuse as well). The fuse is fine as the cig lighter still works.
Looking for any suggestions at this point.
Thanks.
I installed a CodeAlarm remote start 5054 and the FLCAN from FlashLogic.
I'm using the data connection method between the RS and the FLCAN.
Everything looks connected properly and I get continuity from the data port and the wires into the flcan.
There is a programming/pairing procedure on the FLCAN even before getting to program the RS.
I get the flashing green light, then the solid green. When I insert key and to 'Start' (the position right before the starter kicks on) where the directions (and crutchfield) say to have it, I never get the confirmation solid green.
Has anyone had this issue? I cannot get to the RS programming.
I have had the ODBII port read before and at one point, the fuse was bad (a while back when i discovered that the Cig lighter is connected through that fuse as well). The fuse is fine as the cig lighter still works.
Looking for any suggestions at this point.
Thanks.