Help!

[Bedeville]

So this weekend I replaced my fuel pump. I also had to repair a fuel line. In doing so I had to pull back a wiring harness to get to the fuel line. got everything button back up and truck was running great. Unfortunately, I did not secure the harness back and it got wrapped around the axle going to the front diff. Whatever harness it was took out two O2 sensors the float valve for the pump, and the evap purge valve the AC compressor will not kick on either. If anybody has a part number or what this particular harness would be called it would be great. I know I can buy pigtails Andre make the harness but if I could find the actual harness that got ripped off it would be a whole lot easier on my life since I'm not a really good electrician. Or mechanic either for that matter.

 

[Navigatin1]

That sucks dude!!

If you can’t locate the harness, I’d take the time to rebuild that one. Depending on how bad it is, you’ll need some wire, solder, soldering iron, heat shrink, and some waterproof electrical tape.

Let’s say it damaged 2ft of wire harness. Count up how many wires are damaged, then pre-cut that many pieces, strip the ends, and tin them up with solder. That way you can replace one wire at a time making sure that the colors match on both ends.