Led bulbs tail lights (fast blinking)

[Wpolonavyguy]

Hey all, I added led bulbs to the lower bulb breaks & blinkers. Having the fast blinking and purchased the resistors to try fixing speed.
Have four black wires & two yellow to the led bulbs.
Anyone know what two wires I should splice the resistors across to get correct blinking speed?
It works ok as is but looks odd from outside truck & faster clicks sometimes annoying.
My best guess is the yellow & black I put gator clips on but don't want to cut or mess with it till more sure.

 

[Rassilon]

How to wire load equalizers?

I ordered some led switchback bulbs for the front parking lights/turn signals along with two load equalizers. It sounds like I need to attach one of the wires to the negative wire from the turn signal and the other wire to the positive 12volt feed of the signal flash power input wire. The...

www.chevyavalanchefanclub.com

You will need four for the back & two for the front.

I mounted the rear in metal project boxes secured underneath, the front I secured to the metalwork behind the headlights, by drilling & securing with metal self tappers one cable end was terminated to the body of the resistor & the vehicles ground with one of the screws, the other end was wired into the main body of the wiring harness (Not the headlight assembly wiring) & taped up.

 

[Wpolonavyguy]

How to wire load equalizers?

I ordered some led switchback bulbs for the front parking lights/turn signals along with two load equalizers. It sounds like I need to attach one of the wires to the negative wire from the turn signal and the other wire to the positive 12volt feed of the signal flash power input wire. The...

www.chevyavalanchefanclub.com

You will need four for the back & two for the front.

I mounted the rear in metal project boxes secured underneath, the front I secured to the metalwork behind the headlights, by drilling & securing with metal self tappers one cable end was terminated to the body of the resistor & the vehicles ground with one of the screws, the other end was wired into the main body of the wiring harness (Not the headlight assembly wiring) & taped up.

Appreciate the help, I had thought needed more resistors after seeing how the rear lights were wired. The only led was x2 stage had all four yellow wires & two black.
Hoped could figure out how add resistance for just that 1 bulb.
I might try changing bulb back till buy led bulbs for all.

 

[Rassilon]

I did the rear ones first around April (Easy access), I did the front ones in September when I was still deliberating to fit new headlight assemblies or try a headlight restoration kit & fit the front with LED's throughout at the same time. So one resistor per LED bulb at the time of fitting (You can mix & match front & rear).

 

[joendoodle]

Over time I am slowly changing out several bulbs on the "Green Booger" to LED's. To make it "simple" I replaced the blinker module with one of these:
I learned about it on this forum (somewhere), In practice what you lose is the feature that: when a "bulb" burns out the flasher slows down..
with this unit it is the same flash rate no matter the load.

Hazard Warning and Turn Signal LED Flasher Relay Module, Fix Hyper Flash Created by LED Bulb Replacement, Replace LM487 10383321 15231201​