I might be loosing it.
Searching the threads it seems nobody has seen this issue.
2006 1500 4WD LT
Project: Front end rebuild
The new lower control arms do not allow the shocks to bolt into the towers. The bump stop on the arm prevents the shock from rolling back far enough.
If you put new/old arms side by side on the ground with shocks bolted into the arms the top of the shock is allowed to travel inward 4 inches more with the OEM original arm compared to the after marked arm.
I've compared two different after market arms with same results. Both are steel. Same shocks.
Any assistance would be greatly appreciated
Searching the threads it seems nobody has seen this issue.
2006 1500 4WD LT
Project: Front end rebuild
The new lower control arms do not allow the shocks to bolt into the towers. The bump stop on the arm prevents the shock from rolling back far enough.
If you put new/old arms side by side on the ground with shocks bolted into the arms the top of the shock is allowed to travel inward 4 inches more with the OEM original arm compared to the after marked arm.
I've compared two different after market arms with same results. Both are steel. Same shocks.
Any assistance would be greatly appreciated